Home / Metals / HOW DO I replace a roof vent pipe?
Stainless Steel Flanges

HOW DO I replace a roof vent pipe?

Have you ever noticed small water stains near the edge of your ceiling in certain areas and wondered how that can be; you just had your roof replaced a few years ago and the contractor said it was a 25 year roof?

When roof’s are replaced, they are generally sold as a 20 year, 25 year, 35 year, etc. roof job and that makes the homeowner think they shouldn’t experience any more problems until somewhere near that term. A roof job consists of not only shingles but static vents, ridge vents, pipe vent boots, flashings and various other roof penetrations. These various components make up the roof system and not all of the parts have the same life expectancy as others in the roof system.

The plumbing pipe vent boots are the most vulnerable part of the roof system, and the rubber seal type only last 6 to 8 years generally before they begin to crack and split allowing water to pass between the openings in the seal and the pipe vent. This water, depending on the amount that gets in, can deteriorate the roof sheathing, pass on down to the ceiling and show up as water stains and, if severe enough, can trickle on down the wall framing causing wood rot within the wall.

If you see water stains in certain areas of your home, you can go outside and look up on the roof to see if you see a plumbing vent pipe penetrating the shingles, if so, there’s a good chance that is where it is coming from.

To replace a pipe vent boot completely requires a few shingles be removed on the upper side of the boot so the old nailing flange of the vent boot can be removed and replaced with a new one; then the shingles can be re-installed back over the nailing flange. This may be too daunting of a task for the DIY’er. If you hire a roofing contractor to perform this task, it can cost approx. $150 or more depending on the roof pitch, the height of the roof, etc. Multiply this by the number of pipe vents you have and it can get quite costly. Of course the more boots to replace would lower the per boot price but it can still add up pretty quick.

The DIY’er can tackle this job without having to go through all that trouble. Just purchase the vinyl flanged pipe boot and cut the flat flange part off at the shoulder of the boot so that when you’re finished, you end up with what looks like an upside down bowl.

All you have to do is climb up to the pipe boot and slip this altered pipe boot over the pipe and snug it down close to the original pipe boot. No need to remove any shingles. This way, the original flange doesn’t wear out and doesn’t need replacing, only the rubber seal part around the top of the boot does. This method creates a new shield over the old cracked seal.

The new vinyl pipe boots cost about $7 to $8 each, the toughest part will be not to fall off the ladder or the roof, so hold on tight.

northaugustastar

Yaang Pipe Industry

About www.nctv.net

www.yaang.com provide a wide range of steel products as Steel pipe, Steel pipes and seamless pipes, Alloy pipes, Pipe fittings, Composite steel pipe used in the industry, construction etc.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

Scroll To Top