Home / Flanges / How to properly use stainless steel blind flange
Stainless Steel Flanges

How to properly use stainless steel blind flange

Stainless steel blind flange with the rapid development of domestic foreign minister pipeline construction, pipeline pressure test become an indispensable important link, in before, during and after the test must be conducted for each section of the pipeline ball-passing sweep line, generally for 4 ~ 5 times. Especially after the pressure test, pipeline inside water is very difficult to clean, cleaning the number will be more. In the closed ball using repeated construction method of welding head, its existing problems: one is to increase the Labour strength of workers; 2 it is repeated welding consumables high head method, need more large equipment, the cost is high. For long distance pipeline pressure test to pass the ball after the scanning line, at the serve by repeated welding head method of high labor intensity big, consumables, need more large equipment, the problem of high cost, this paper proposes a new simple quick opening large blind flange construction method. The construction method of this article introduces the structure of the fast-opening blind, work steps and intensity. Through application on acerbity NingLan gas transmission pipeline engineering, prove fast-opening blind construction method than repeated three times welding head construction methods to improve work efficiency, not only reduce the labor intensity of workers, and reduce the cost. Stainless steel flanges need to do some preparation work before measurement, measurement, according to certain way and method to determine the different measurement methods, according to the specific situation to ensure the accuracy of the measurement.
To introduce the following Stainless steel blind flange measurement: measure the preparation work before the:
1. According to the large flange position before measurement, should first sketches, equipment each connecting large flange and numbered consecutively, so that the fixture installation to the number, according to certain way and the principle for installation, ensure the normal use.
2. Because when installation of Stainless steel flange diameter is different, possible hi-lo (different), the thickness of the gasket is not equal, so the processing of fixture should correspond to the side of the Stainless steel flanges are not interchangeable, thus measurement by size and number is the key to the fixture processing and installation
3. Measurement, it is best to arrange three people, two of them were measured, and one to proofread and fill out a form, measuring tool use vernier caliper, if there were no conditions available outside calipers and steel ruler. Measurement is a careful work, is the precondition of fixture installation, measure and record must be prepared to correct, when completing this form must be clear. Seriously to each other in the actual measurement to cooperate, can according to the principle of the right to cooperate and use.
Source: China Blind Flange Manufacturer – Yaang Pipe Industry Co., Limited (www.yaang.com)

About www.nctv.net

www.yaang.com provide a wide range of steel products as Steel pipe, Steel pipes and seamless pipes, Alloy pipes, Pipe fittings, Composite steel pipe used in the industry, construction etc.

Leave a Reply

Your email address will not be published. Required fields are marked *